Sable V6-182 3.0L (1986)
FIGURE 2
1.
Adjust the park position of the standard wiper arm to the specification shown in Figure 2.
2.
Cycle the windshield wipers to check if the condition has been resolved. If the condition is still present, proceed to Step 3.
NOTE:
DO NOT PRY THE WIPER ARM FROM THE WIPER PIVOT SHAFT WITH A SHARP TOOL.
3.
With the ignition key in the "ACC" position, turn the wiper switch "ON "and allow the wiper motor to move the wiper pivot shafts three (3) or four
(4) cycles. Then turn "OFF" the wiper switch. This will place the pivot shafts in the "PARK" position.